This instruction is based on the use of a B15 rated bulkhead,
using 19mm thick PROMARINE®-450 and laminated on both sides with 0.8mm thick HPL (high pressure laminate)
Detail D Omega Joint
Omega joints are
generally used in areas where boards
may have to be removed from time to
time. This method allows an
individual board to be removed
without disturbing an adjacent
board. The Omegas should be trimmed
to the required length and loosely
screwed together using the screws
supplied, and inserted between the
boards as shown.
As with the C-spline above, starting
at the corner, boards are pushed
together into the Omegas, and the
screws tightened until a tight fit
is achieved.
